Petsafe Drinkwell® 360 Pet Fountain Manuale Utente Pagina 12

  • Scaricare
  • Aggiungi ai miei manuali
  • Stampa
  • Pagina
    / 32
  • Indice
  • SEGNALIBRI
  • Valutato. / 5. Basato su recensioni clienti
Vedere la pagina 11
www.petsafe.net 13 12 www.petsafe.net
ENFR
5. Once the Pump is disassembled you can clean
the parts with warm soap and water. Use a
cotton swab or the “motor” brush from the
Drinkwell
®
Cleaning Kit to get into the Pump’s
motor cavity and remove any build-up
(Fig.20). For added disinfecting and hard
water removal, clean the Pump with a diluted
vinegar solution (20% white vinegar & 80%
water). Be sure to rinse thoroughly with freshwater.
6. Once the parts are clean you can reassemble the Pump for use.
a) Replace the Impeller.
b) Replace the Intake Plate.
c) Replace the Faceplate.
Pet Fountain Reassembly
1. Place the Foam Filter around the Pump. Make sure the electrical Power Cord runs
over the top of the Foam Filter, not underneath it, as this will keep the Foam Filter
inplace.
2. With the Foam Filter securely around the Pump, replace the Pump into its location
between the four posts in the center of the Bowl. Be sure to position the hole on the
top of the Pump next to the Cord Pass-Through in the Bowl. Gently push down to
engage the suction cups.
3. Replace the Intake Tube into the Intake Tube Holder, then place the Intake Tube
Holder back onto the Cord Pass-Through post aligning the guideline on the post with
the notch in the Intake Tube holder. Be careful to align the Intake Tube so that it fits
into the hole on the top of the Pump.
4. Thread the In-Line Plug through the Cord Pass-Through
next to the Pump. On the bottom side of the Bowl, clip
the electrical Power Cord into place using the Cord
Clips (Fig. 21). Next, thread the electrical Power
Cord directly out of the Pet Fountain through the notch
in the side of the Bowl (Fig. 22 & 23).
Fig. 20
Fig. 21
Cord Clips
Notch
Fig. 22
Fig. 23
Notch
Vedere la pagina 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Commenti su questo manuale

Nessun commento